Arctic Cat DVX 300 Manuel de l'opérateur télécharger pdf (Page 50)

48

 NOTE: Normal operating range is

from the bottom segment (C) up to

but not including the top segment

(H). In the event the top segment (H)

is displayed, all segments of the

display and the temperature icon

will flash indicating high engine

temperature.



NOTE: High engine RPM, low vehi-

cle speed, or heavy load can raise

engine temperature. Decreasing

engine RPM, reducing load, and

selecting an appropriate transmis-

sion gear can lower the temperature.

 NOTE: Debris in front of the

engine (or packed between the

cooling fins of the radiator) can

reduce cooling capability. Using a

garden hose, wash the radiator and

the engine to remove any debris

restricting air flow.

4. Speedometer (4) - Displays approx-

imate vehicle speed in mph or km/h.

 NOTE: To shift the display

between mph and km/h, press the

Mode/Set Button for two seconds.

The LCD will display either mph or

km/h on the right-side of the dis-

play. The Odometer/Trip Meter (7)

will shift to correspond (miles/kilo-

meters) with the speedometer.

5. Fuel Level Indicator (5) - Indicates

approximate amount of gasoline in

the gas tank.



NOTE: When the bottom segment

flashes, gasoline quantity is low.

6. Digital Clock (6) - Displays time in

hours and minutes when the ignition

switch is turned to the ON position.

To set the time, turn the ignition

switch to the ON position; then use

the following procedure.

 NOTE: If the Hour Set or Minute

Set operation is interrupted for

more than 10 seconds, the clock

will return to normal operation.

A. Hour Set: Press and hold Mode/

Set Buttons (1) and (2) until the

hour display flashes; then

release both buttons and again

press Mode/Set Button (2) to

select the desired hour. When

the desired hour is displayed,

release the button.

 NOTE: The clock displays a

sequential 24-hour time only. There

is no 12-hour AM/PM designation.

B. Minute Set: Press and hold

Mode/Set Button (1) until the

minute display flashes; then

release the button and press

Mode/Set Button (2) to select

the desired minute. When the

desired minute is displayed,

release the button.



NOTE: When the button is released

for more than 10 seconds, the clock

will return to normal operation.

7.

Odometer/Trip Meter (7)

- Displays

distance in miles or kilometers the

vehicle has traveled. The odometer

(ODO) displays total distance and

cannot be reset to zero. The trip

meter (TRIP) displays distance and

can be reset to zero. The distance

(miles/kilometers) will correspond to

the speedometer. To shift between

(ODO) and (TRIP), press and hold

Mode/Set Button (2) for two seconds.

To reset the (TRIP) display to zero,

shift the display to (TRIP); then press

and hold Mode/Set Button (2) and

simultaneously press Mode/Set But-

ton (1) until the display reads zero.

Release the buttons.

CAUTION

Continued operation of the ATV with

high engine temperature may result

in engine damage or premature wear.

CAUTION

Arctic Cat does not recommend using

a pressure washer to clean the radia-

tor core. The pressure may bend or

flatten the fins causing restricted air

flow, and electrical components on

the radiator could be damaged. Use

only a garden hose with spray nozzle

at normal tap pressure.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 83 84

Commentaires sur ces manuels

Pas de commentaire