Arctic Cat DVX 300 Manuel de l'opérateur télécharger pdf (Page 61)

59

 NOTE: The sealing strip should

NOT be removed and NO fluid

should be added.

3. Be sure the charger and battery are

in a well-ventilated area. Be sure the

charger is unplugged from the 110-

volt electrical outlet.

4. Connect the red terminal lead from

the charger to the positive terminal

of the battery; then connect the black

terminal lead of the charger to the

negative terminal of the battery.

 NOTE: Optional battery charging

adapters are available from your

authorized Arctic Cat dealer to con-

nect directly to your vehicle from the

recommended chargers to simplify

the maintenance charging process.

Check with your authorized Arctic

Cat dealer for proper installation of

these charging adapter connectors.

5. Plug the battery charger into a 110-

volt electrical outlet.

6. If using the CTEK Multi US 800,

there are no further buttons to push.

If using the CTEK Multi US 3300,

press the Mode button (A) at the left

of the charger until the Maintenance

Charge Icon (B) at the bottom illu-

minates. The Normal Charge Indica-

tor (C) should illuminate on the

upper portion of the battery charger.

800E

 NOTE: The maintainer/charger

will charge the battery to 95%

capacity at which time the Mainte-

nance Charge Indicator (D) will illu-

minate and the maintainer/charger

will change to pulse/float mainte-

nance. If the battery falls below 12.9

DC volts, the charger will automati-

cally start again at the first step of

the charge sequence.

3300A

 NOTE: Not using a battery char-

ger with the proper float mainte-

nance will damage the battery if

connected over extended periods.

Charging

 NOTE: Arctic Cat recommends

the use of the CTEK Multi US 800 or

the CTEK Multi US 3300 for battery

maintenance charging.

1. Be sure the battery and terminals

have been cleaned with a baking

soda and water solution.

 NOTE: The sealing strip should

NOT be removed and NO fluid

should be added.

2. Be sure the charger and battery are

in a well-ventilated area. Be sure the

charger is unplugged from the 110-

volt electrical outlet.

3. Connect the red terminal lead from

the charger to the positive terminal

of the battery; then connect the black

terminal lead of the charger to the

negative terminal of the battery.

4. Plug the charger into a 110-volt elec-

trical outlet.

5. By pushing the Mode button (A) on

the left side of the charger, select the

Normal Charge Icon (E). The Nor-

mal Charge Indicator (C) should

illuminate on the upper left portion

of the charger.

6. The battery will charge to 95% of its

capacity at which time the Mainte-

nance Charge Indicator (D) will illu-

minate.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 83 84

Commentaires sur ces manuels

Pas de commentaire