Arctic Cat DVX 300 Manuel de l'opérateur télécharger pdf (Page 64)

62

To properly adjust the idle, a tachometer is

necessary. If one is not available, take the

ATV to an authorized Arctic Cat ATV dealer.

To adjust idle RPM:

1. Start the engine and warm it up to

normal operating temperature.

2. Turn the idle adjustment screw in or

out until the engine idles at 1250-

1350 RPM.

Throttle Cable

Adjustment

To adjust the throttle cable free-play:

KM111A

1. Slide the rubber boot away; then

loosen the jam nut (1) from the

throttle housing.

2. Turn the throttle cable adjuster (2)

until the throttle lever has proper

free-play of 3-5 mm (1/8 - 1/5 in.).

3. Tighten the jam nut (1) against the

throttle housing securely; then slide

the rubber boot over the adjuster.

Air Filter (V-Belt

Housing) - Utility

The air filter in the V-belt housing cooling

inlet must be kept clean. If the ATV is used

under normal conditions, service the filter

at the intervals specified. If operated in

dusty, wet, or muddy conditions, inspect

and service the filter more frequently. Use

the following procedure to remove the fil-

ter and inspect and/or clean it.

1. Remove the center cover from

between the front fenders; then

remove the two screws securing the

filter housing to the front fender.

2. Remove the filter housing cover. Tap

the filter lightly to remove dust and

debris; then use compressed air to

thoroughly clean the filter.

 NOTE: Inspect the filter element.

If damaged or torn, it must be

replaced.

3. Install the filter housing cover onto

the filter housing.

4. Place the filter housing into position

on the front fender. Tighten the two

screws securely; then place the cen-

ter cover into position between the

front fenders. Tighten the screws

securely.

Air Filter (V-Belt

Housing) - DVX

The air filter in the V-belt housing cooling

inlet must be kept clean. If the ATV is used

under normal conditions, service the filter

at the intervals specified. If operated in

dusty, wet, or muddy conditions, inspect

and service the filter more frequently. Use

the following procedure to remove the filter

and inspect and/or clean it.

1. Remove the two screws securing the

filter housing to the inside of the

left-front fender.

2. Remove the filter housing cover. Tap

the filter lightly to remove dust and

debris; then use compressed air to

thoroughly clean the filter.

 NOTE: Inspect the filter element.

If damaged or torn, it must be

replaced.

3. Install the filter housing cover onto

the filter housing.

4. Place the filter housing into position

inside the left-front fender. Tighten

the two screws securely.

! WARNING

Adjust the idle to the correct RPM.

Make sure the engine is at normal

operating temperature before adjust-

ing the idle RPM.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 83 84

Commentaires sur ces manuels

Pas de commentaire