Arctic Cat DVX 300 Manuel de l'opérateur télécharger pdf (Page 69)

KM192A

3. Install the new bulb into the hous-

ing; then secure with the spring clip.

KM195

4. Connect the three-wire connector to

the bulb; then install the rubber boot.

To replace the taillight/brakelight bulb,

use the following procedure.

1. Remove the two screws and remove

the lens.

KM143B

2. Push the bulb in and turn it counter-

clockwise.

3. Install the new bulb by turning it

clockwise while pushing in.

4. Install the lens. Tighten the two

screws securely.

Fuses

The fuse box (with three active fuses and

one spare fuse) is located under the seat

near the battery.

KM102

 NOTE: To remove the fuse, com-

press the locking tabs on either

side of the fuse cover and lift off;

then remove and replace the fuse.

Tools

A basic tool kit, located under the seat, is

provided with the ATV. Maintain the tool

kit with the ATV at all times.

CAUTION

When replacing the headlight bulb,

be careful not to touch the glass

portion of the bulb. Grasp the new

bulb with a clean cloth.

CAUTION

Always replace a blown fuse with a

fuse of the same type and rating. If

the new fuse blows after a short

period of use, consult an authorized

Arctic Cat ATV dealer immediately.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 83 84

Pas de commentaire

Arctic Cat DVX 300 Manuel de l'opérateur Page 69